Metal Building Insulation Door and Window Installation FAQs
Pre-Assembled Existing Opening Doors
Q: How do we prep for a partial masonry in doors?
A: Existing opening anchors should be used for the masonry, and subframes should be used for the metal building portion
Q: Can a masonry door be installed into a block wall after the wall is up?
A: Yes, using existing opening anchors
Thermal Frame Windows
Q: Is caulk required during the install for thermal frame windows?
A: Yes
General
Q: What are the three things to check for that are critical for a door installation?
A: The concrete floor must be level, the door frame must be square, and the door frame must be plumb
Q: When would a header subframe be required?
A: When there are liner panels on the interior of the building
Q: What is the one component on a preassembled door that does NOT come installed?
A: The removable mullion for a double active 6070
Q: Does Therm-All have a window system that can be installed into an insulated wall panel that is deeper than 4″?
A: Yes
Q: What do local codes sometimes require concerning the wall / frame connection on a fire door?
A: That a portion of the wall is embedded into the throat of the frame
Talk to A Therm-All Expert!
Therm-All has been at the forefront of innovative metal building insulation solutions since 1981. We are a trusted partner of Owens Corning and the AIA, and we are a proud member of NIA, MBMA and MBCEA.